Florabest FTP 400 B2 User Manual download pdf (Page 33)

33

GB

adapter (11) (see “replacing backow

stopper”). This is particularly recom-

mended for hose connections smaller than

1“. Please bear in mind that the water may

then ow back during pumping, or in the

event of a power cut.

To erect / suspend

The pump can be erected or sus-

pended in the water.

The cord ( 12) contained in the

delivery contents may be used to

suspend and/or extract the pump.

The pump shaft should have the dimen-

sions 40 x 40 x 50cm at least, so that the

oat switch can move freely.

Fix the nylon rope (12) onto the car-

rying handle (1).

Ensure that the equipment is

not hung up or held by the

mains cable. There is a risk

of electric shock from dam-

aged mains cables.

Note that, over time, dirt and sand

may collect on the bottom of the

shaft, which could damage the

pump.

We recommend standing the pump

on a brick.

If the water level is too low, the silt in

the shaft can quickly dry out and im-

pede the pump when warming up.

Controls before operational

start-up

• Check that the oat switch is

working (see chapter: “Opera-

tion“).

• Check that the pump is resting

on the pit base

• Check that the pressure line has

been attached properly

• Check the proper status of the

electrical plug socket and make

sure that the plug socket is suf-

ciently fused (at least 6 A). In-

sert the pump plug into the plug

socket and the pump is ready for

operation.

• Make sure that moisture or water

never come in contact with the

mains connection.There is a risk

of electrocution.

Operation

Mains connection

The submersible water pump acquired by

you is already provided with an grounded

plug. The equipment is designed for con-

nection to an earthed wall socket with a

residual current operated device (RCD

switch) at 230 V ~ 50Hz.

Only start to operate the device

after all the above conditions have

been observed.

Switching on and off

1. Insert the plug in the socket. The pump

starts working immediately.

2. To switch off, withdraw the plug from

the socket. The pump stops.

If the water level is too low, the

oat switch will automatically

switch off the pump.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 53 54

Comments to this Manuals

No comments