Florabest FTP 400 B2 User Manual download pdf (Page 47)

47

GB

Working

Supervise the appliance while it is

in operation in order to be immedi-

ately aware if the automatic cut-out

operates or the pump runs dry, to

limit any damage to a minimum.

In automatic mode, the oat switch auto-

matically switches the pump on or off.

Adjustingtheoatswitch:

The on/off switch point on the oat switch

(

6) can be adjusted by changing the

position of the oat switch in the oat

switch grid (

8).

In the case of stationary installation,

check regularly (no less then once

every three months) that the oat

switch (

6) is working.

  Checktheoatswitch( 6):

- It must be positioned so that it

can lift and lower freely. The

switching point heights “On”

and “Off” must be easy to

reach.

Check this by placing the pump

into a vessel lled with water

and lift the oat switch (6) care-

fully by hand and then lower it

again. In this case, you can see

whether the pump switches on

and off.

- Ensure that the distance between

the oat switch and the oat switch

grid (

8) is not too small.

- During the adjustment of the oat

switch (6), ensure that the oat

switch does not contact the oor

before the pump switches off.

The pump will run dry if too long a

oat switch cable (

7) is chosen.

Maintenance and

Cleaning

Clean and maintain your equipment regu-

larly. This will guarantee its performance

and long durability.

Ask our service centre to car-

ry out any work that is not

described in these instruc-

tions. Use only original parts.

There is a risk of injury!

Pull out the power plug before eve-

ry maintenance operation. There is

a risk of electrocution or of injury

from moving parts.

General cleaning instructions

• In case of transport for utilization in

different locations, the pump must be

cleaned with clear water after every use.

• In case of stationary installation, the

function of the oat switch (

6) is

to be checked regularly (at the latest

every three months).

• With a water jet, remove uff and

brous particles which are possibly

present in the pump casing (

3).

• Clean precipitation from the oat

switch (

6) with clear water.

• Regularly remove sludge from the pit

base (at the latest every 3 months) and

also clean the shaft walls

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 53 54

Comments to this Manuals

No comments